BABY QUASAR - DIRECTIONS

Starting at section A, move the wand slowly over that area for two minutes. Press lightly, only firmly enough to keep the face of the Baby Quasar against the skin. Try not to let light escape, as only the light penetrating will have a therapeutic benefit. A soft tone will sound signaling you to move to the next area.

Next move clockwise to section B. Slowly move the wand over that area for two minutes. Moving in a clockwise direction, treat each section C, D, E, F. After treating all six sections, continue by repeating the treatment a second time using the Continuous Wave (Green LED) or High Frequency (Red LED).

If you have special areas of concern, use the light for another two minutes in those areas on the Continuous Wave (Green LED) strength setting.

Push the button on the back of the wand until indicator light is not shining and LEDs turn off. You are now finished with the treatment. After disconnecting the unit from the power source, clean the equipment by wiping the wand with alcohol. Use cotton swabs dipped in alcohol to gently clean the LEDs. Do not immerse the device in water. Unplug the power supply from the outlet and place in a secure place. We suggest the pouch that came with your Baby Quasar unit.

BABY QUASAR - TREATMENT RECOMMENDATION

Preparation

A clean face is important in Light Therapy treatment. Remove all makeup and jewelry from areas to be treated. Clean the area to be treated with your favorite pH balanced cleanser.

Apply the Pure Silk HA serum as per instructions. You may also safely use the Baby Quasar with your favorite topical cosmetic as long as the product does not leave a barrier on the skin which could prevent the light from penetrating. The Baby Quasar will increase the effectiveness of the products.

Recommended Useage

Light Treatments with the Baby Quasar are recommended to be used 2 to 3 times per week for approximately 24 to 36 minutes each treatment. Overuse of this device may result in dryness of skin. Results may vary based on skin type and skin damage.

Allow 48 hours between treatments, to optimize the skin's regenerative cycle. The result is decrease in appearance of file lines, wrinkles, enlarged pores, and age spots. The skin will feel smoother and firmer and look younger

Push the button on the back of the wand until indicator light is not shining and LEDs turn off. You are now finished with the treatment. After disconnecting the unit from the power source, clean the equipment by wiping the wand with alcohol. Use cotton swabs dipped in alcohol to gently clean the LEDs. Do not immerse the device in water. Unplug the power supply from the outlet and place in a secure place. We suggest the pouch that came with your Baby Quasar unit.